Before drilling holes into your walls, you must map out your surveillance footprint. Good planning saves hours of troubleshooting and ensures you do not end up with critical blind spots. Choosing the Right Camera Locations
Use a "corner-to-corner" or "back-to-back" pattern to ensure one camera watches the other's back. 2. Gather Your Essential Tools Before you start drilling, make sure you have the right installation gear
Most commercial network cameras rely on Power over Ethernet (PoE) to receive power and transmit data over a single Cat5e or Cat6 cable.
How to set up a network camera (a.k.a. IP camera) - IP Centcom Before drilling holes into your walls, you must
When installing network cameras outdoors, never leave the RJ45 Ethernet connection exposed to the elements. Mount a weatherproof junction box over the cable hole, pass the wire inside, plug it into the camera tail, and seal the box. Step 5: Attach and Angle the Camera
Before permanently screwing a camera into a wall, temporarily power it up inside. Connect it to your network to verify that the lens angle, field of view, and focus meet your expectations. Step 2: Run the Infrastructure Cables
Plug each Ethernet cable into the PoE ports on the NVR or switch. IP camera) - IP Centcom When installing network
The router automatically assigns an IP address. While easy, this address can change if the system reboots, breaking connections to management software.
Inspect physical enclosures, conduits, and cable connections for water intrusion, corrosion, or wear.
Never use dynamic DHCP addressing for commercial security installations. and cable connections for water intrusion
Run Cat5e or Cat6 cables from each camera location back to your NVR or PoE switch.
To protect cable connections from moisture when mounting cameras outdoors.