, though it is always recommended to refer to the specific physical manual included with your unit for precise wiring diagrams. or a list of UART serial commands for this module?
The XY-CD60 is a multi-functional battery controller designed to automate the charging and discharging cycles of DC batteries. Supporting a wide voltage range (6V to 60V), it acts as a safeguard against overcharging and deep discharging, which are critical factors in extending battery lifespan. 2. Technical Specifications Voltage Range: DC 6V–60V. Control Accuracy: Output Type: Direct output (Relay switch). Voltage Error: plus or minus 0.1 cap V Primary Modes: Charging Control (P-1): Activates when battery voltage drops below a lower limit. Discharging Control (P-2): Activates when battery voltage exceeds an upper limit. 3. Operating Modes and Logic
If no battery is detected at the output during charging mode, the screen will display "nbE" and 0.00V. xycd60 manual
Long-press the DOWN button to set the LCD backlight to OFF (always on) or ON (auto-off after 5-10 minutes). 5. Typical Use Cases A. Charging Lead-Acid Battery (12V) Set Mode: IN (Charge Mode) UP (Upper): 14.4V (Voltage to stop charging) dn (Down): 11.0V (Voltage to start charging) B. Discharging/Protecting a 3S Li-ion Battery Set Mode: OUT (Discharge Mode) UP (Upper): 12.6V (Full capacity) dn (Down): 9.0V (Safety cutoff voltage) 6. Troubleshooting
Used to prevent overcharging. The relay closes (starts charging) when the battery voltage drops to the lower limit ( , though it is always recommended to refer
You can set a delay (0-999 seconds) between cycles, which is useful for allowing batteries to stabilize or "rest" between charge and discharge phases.
: Here, your battery is the input, and your load (e.g., a DC light) is the output. Set "UP" to the maximum voltage you allow (often left high as a failsafe). Set "dn" to the minimum safe voltage for your battery (e.g., 11.0V for a 12V battery). As long as the battery voltage is above 11.0V, the module will power your light. If the voltage drops to 11.0V, it will disconnect the light, preventing your battery from being drained completely and permanently damaged. Supporting a wide voltage range (6V to 60V),
) and opens (cuts off load) when the voltage falls to the lower limit ( 3. Setting Parameters To configure the module, use the following button sequence: Enter Setting Mode: Long press the Switch Parameters: Short press to cycle through parameters: (upper limit), (lower limit), and (time control). Adjust Values: buttons to increase or decrease values. Save and Exit: Long press for 5 seconds to save and return to the main interface. Switch Modes: Long press the button for 5 seconds to toggle between Charging ( ) and Discharging ( 4. Advanced Functions